Electronic repair · Buenos Aires / CABA
Water pumps & electric motors
We focus on pumps and motors that include starter electronics, capacitor switching electronics or integrated drives.
Purely electromechanical motors are screened before promising scope.
How we decide repairs
We do not replace parts without diagnosis. We inspect the fault first, assess whether repair makes sense, and only then confirm an estimate.
Component-level repair: whenever feasible we restore the original board by replacing damaged components, traces, connectors, relays, capacitors, internal supplies or control elements—avoiding unnecessary full module swaps.
Typical faults we investigate
- Pump starts then stops via electronics
- Overheat from poorly suppressed relays
- Pressure sensors blocking start
- Integrated speed drives glitching
Equipment we can inspect
- Peripheral and submersible pumps with cards
- Motors with electronic soft-start
- Compact drives bolted to motors
What diagnosis looks like here
- Insulation checks when applicable
- Winding continuity if the customer flagged issues
- Power stage & sensor evaluation
- Repair vs replace guidance
Technical diagnosis starts from 50,000 ARS. If after the diagnosis you decide to repair the device with us, the diagnosis is not charged separately. If you decide not to proceed with the repair, the diagnosis fee applies. The usual diagnosis time is up to 7 days. For simple repairs, the work may be completed within the same week. The final repair cost is confirmed after checking the device.
What to send on WhatsApp
- Install type (home, well, etc.)
- Nominal voltage and protections
- Board photos when present
Warranty
The warranty applies to the repaired fault and the work performed. It does not cover new faults, impacts, humidity, misuse, low voltage, external short circuits, or issues in other components that were not repaired.
FAQ about this service
We specialise in the electronic side; rewinds may be referred out.