Electronic repair · Buenos Aires / CABA
Washer, microwave & refrigerator boards
We troubleshoot washing, refrigeration and microwave modules when supplies, start relays, sensors or command circuits fail.
We don’t guess parts—measurements come first.
How we decide repairs
We do not replace parts without diagnosis. We inspect the fault first, assess whether repair makes sense, and only then confirm an estimate.
Component-level repair: whenever feasible we restore the original board by replacing damaged components, traces, connectors, relays, capacitors, internal supplies or control elements—avoiding unnecessary full module swaps.
Typical faults we investigate
- Washer stops mid-cycle or won’t spin
- Microwave dead magnetron drive but UI alive
- Fridge fans stuck commanded wrong
- Mains spikes damaging rectifier stages
Equipment we can inspect
- Washer and dishwasher boards
- Microwave modules and auxiliary supplies
- No-frost fridge controllers
- Inverter cards after feasibility review
What diagnosis looks like here
- Optocouplers and relay inspection
- Internal supply rails measurement
- Equivalent load tests when safe
- Quote before swapping entire modules
Technical diagnosis starts from 50,000 ARS. If after the diagnosis you decide to repair the device with us, the diagnosis is not charged separately. If you decide not to proceed with the repair, the diagnosis fee applies. The usual diagnosis time is up to 7 days. For simple repairs, the work may be completed within the same week. The final repair cost is confirmed after checking the device.
What to send on WhatsApp
- Appliance label photo
- Board photo if already removed
- Which programme or cycle fails
Warranty
The warranty applies to the repaired fault and the work performed. It does not cover new faults, impacts, humidity, misuse, low voltage, external short circuits, or issues in other components that were not repaired.
FAQ about this service
We assess schematic/part availability per brand and model.